Cement testing machines
Cement testing equipment
Moisture storage cabinet
For the standardized storage of cement and mortar samples in triple molds according to EN 196.
The samples produced are stored in a moisture storage cabinet, protected against drying out, until the test date. The relative humidity in the humidity chamber is 95% and the temperature is + 20 ° C.
Our storage cabinets are made entirely of stainless steel and the innovative differential pull-outs allow the molds to be stored easily.
Our product meets the standard requirements for moisture storage cabinets according to
EN 196.
Wet storage basin
For standard-compliant, standing or lying storage of cement and mortar samples according to EN 196.
The demolded specimens are stored in a static water bath on PVC grids until the test date.
Our product has electronic temperature monitoring so that the water temperature is constantly regulated to + 20 ° C. Our intelligent system is equipped with the option for automatic water change. The water level is drained by 50% and completely refilled with fresh water.
Our product meets the standard requirements for wet storage basins according to EN 196.
Vibrating table
Our proven vibrating table is suitable for standard-compliant compression of cement in a triple shape.
Thanks to the adjustable eccentric stops, different mold sizes can be clamped onto the vibrating plate very quickly and with little effort.
The oscillation width can be freely adjusted up to 1mm using a potentiometer and is shown on the digital display. Integrated control lights indicate that the set amplitude is exceeded or not reached.
Our product fulfills the standard regulations for vibrating tables according to
EN 196-1, EN12808-3, EN 459 and DIN 18555-3.
Precision test forms including model VDZ
Our precision test forms are used for the production of cement and mortar samples in research and development laboratories in the cement and mortar industry.
We offer our product in different versions.
Our product meets the standard requirements for shapes according to
EN 196-1, DIN 1164, DIN 52450 and EN 14891.
Hägermann - Flow table
The slump test is a method for determining the slump, an important parameter for the consistency of freshly prepared mortar-cement samples.
We offer our product in different versions.
Our product meets the standard requirements for Hägermann spreading tables according to
EN 459-2, DIN EN 413-2, DIN EN 1015-3 and 13395-1.
Compression / bending device
With our compression / bending device you can determine the compressive and flexural strength of your cement and mortar samples. Reliable testing with precise measurement results is only possible with a functioning device.
With our wide range of devices, our product covers the test areas for compressive, flexural and tensile strength.
Our product complies with the standard requirements for devices according to
EN 196-1, EN1015-11, EN13279.2, EN13813 and ASTM C 349.
Mortar mixer
Our mortar mixer is used to produce cement mortar and cement paste. The standardized mixing speed is already pre-programmed. Our product design can be configured with or without automatic sand and water dosing.
Our product complies with the standard requirements for mortar mixers according to
DIN 1164, EN 196, ISO R / 679, ASTM C305 and BS 450.
Stiffness measuring device
Our bestseller is used to check the consistency of plaster and wall ties.
The consistency of fresh mortar is determined by the fact that the standard-defined drop weight falls freely from the specified height into the material sample.
Our product meets the standard requirements for stiffness measuring devices according to
EN 413-2, DIN 4211, EN 1015-4 and EN 459-2.
